Siding repair and replacement
Siding repair and replacement for Atlanta houses
Damaged siding is rarely just cosmetic. Once water gets behind a board it works on the sheathing and framing, so we find where it's getting in before we replace anything.
Calls answered 24/7. Crews staged from the Atlanta service office.
- Answered 24/7
- Profile matched to your house
- Painted to blend in
Quick answer
Siding repair in Atlanta usually comes down to water: Georgia's humidity keeps wood swelling and shrinking, and storms drive rain behind failed caulk. Wood siding holds paint roughly 5 to 7 years here, and boards that go soft or split need replacing, not painting over. We cut out damaged sections, check the sheathing, and install matching boards painted to blend.
Updated September 2026
The job
Finding the cause before replacing boards
Most siding damage starts at a detail: a window head with failed caulk, a gutter spilling onto a wall, a board too close to the soil. Replacing the siding without fixing that detail just gives the water a new board to rot.
Replacement boards are matched to your profile and exposure, from James Hardie fiber cement to LP SmartSide or cedar lap, then primed on all sides, sealed with OSI or similar caulk and painted.
What moves the price
What moves the price of siding repair
- How much is damaged
A few boards cost far less than a full wall section.
- Siding type
Wood, fiber cement and vinyl differ in material and labor.
- Profile matching
Discontinued or custom profiles may need milling or sourcing.
- Sheathing damage
Wet or rotted sheathing behind the siding is replaced.
- Height and access
Second-story walls need ladders or staging.
- Painting to blend
New boards are primed and painted, often with the full wall.
What we handle
Siding we repair and replace
Wood siding repair
Cedar and pine lap siding fails from the bottom edge and the butt joints first, where water sits longest. We probe boards with an awl, cut out the soft sections between studs, and replace them with primed stock milled to the same profile. Every new board is back-primed and end-primed before it goes up, because bare cut ends soak up water. Where only the paint has failed and the wood is sound, a scrape, prime and repaint is enough.
Fiber cement siding replacement
Fiber cement doesn't rot, but it cracks from impact, gets damaged when installed too close to the roofline or grade, and swells at cut edges that were never sealed. We replace cracked planks with matching James Hardie or equivalent profiles, keep the manufacturer's clearance above roofs, decks and soil, and seal field-cut ends. Fiber cement is also the common upgrade when wood siding has failed across a whole wall. It arrives primed and takes paint well once installed.
Vinyl siding repair
Vinyl panels crack in cold snaps, melt near grills and blow loose in storms. Because vinyl locks panel to panel, a damaged piece can usually be unzipped and replaced without disturbing the wall around it. The hard part is color: older vinyl fades, so an exact match often means borrowing a panel from a hidden wall and putting the new one there. We check the house wrap underneath while the panel is off, since a tear there is how water reaches the sheathing.
Siding section replacement
When damage runs across a whole wall or around a window, spot repairs stop making sense. We remove the siding in that area, inspect and replace wet sheathing, add flashing at windows and doors, and install new siding tied into the existing courses. The new section is primed and painted with the rest of the elevation so it doesn't read as a patch. It is often the right call on the side of a house that takes the most rain.
Your options
Wood, fiber cement or vinyl
What each siding type asks of you in Atlanta's climate.
| Material | Rot resistance | Paint life | Upkeep |
|---|---|---|---|
| Wood | Low without upkeep | About 5 to 7 years | Caulk and repaint regularly |
| Fiber cement | High | Long when edges are sealed | Low |
| Vinyl | High | Not painted; color fades | Wash, replace damaged panels |
Around Atlanta
Why siding fails early around Atlanta
Georgia averages over 70 percent humidity, and wood siding swells and shrinks with every swing until the paint film cracks. Summer storms then drive rain behind old window caulk, and trapped water pushes paint off from the inside and softens the boards. That's why siding damage in Atlanta shows up first on south and west walls, where sun cycles are hardest, and on shaded north walls, where mildew holds moisture against the wood.
Coatings and materials we work with
Step by step
How a siding repair runs
- 1
Probe and trace
Soft boards mapped and the water source found.
- 2
Remove
Damaged siding cut out without harming sound courses.
- 3
Repair behind
Wet sheathing replaced, wrap and flashing restored.
- 4
Install
Matching boards fitted, primed on all sides and sealed.
- 5
Paint
New siding painted to blend with the rest of the wall.
Warning signs
Signs your siding needs repair
- Soft or spongy boards
An awl or screwdriver sinks into the wood.
- Paint peeling in one area
Moisture pushing out from behind the siding.
- Split or cracked planks
Impact, movement or water damage opening the board.
- Warped or loose panels
Siding pulling away from the wall.
- Mildew that returns
Water held against the wall on a shaded side.
- Stains inside by a window
Water getting past the siding into the wall.
- Gaps at trim and corners
Failed caulk letting rain behind the siding.
Questions
Siding repair questions
Usually. Common lap and fiber cement profiles are stocked; older or unusual wood profiles can be milled to match.
Rarely. Most damage is local to a wall or a detail, and sections can be replaced and painted to blend.
No. Paint won't hold on rotted wood, and the rot keeps spreading underneath.
On walls that keep rotting, often yes. It doesn't rot and holds paint well when edges are sealed.
We paint new boards with the surrounding wall so there is no visible patch.
Also in Repair & Restoration
Related work from the same crews
- Fascia board replacement
- Ceiling stain repair
- Caulking and weatherproofing in Atlanta
- Crown molding and trim carpentry in Atlanta
- Drywall installation in Atlanta
Before you book, read our wood rot guide.
Soft boards or a damaged wall? Call before it spreads
Describe where the damage is and we'll set up a visit to probe the boards.
Call (470) 887-8741Answered 24/7 from 565 Tift St SW Ste b, Atlanta.
Where we start from